When you are looking for a new faucet for your kitchen, you should follow these tips to ensure a smooth replacement. First, turn off the shut-off valves of water, waste and gas in the house. Using bright lighting is helpful to see where you need to work and where you should avoid. Unhinge the nuts underneath the existing faucet. You can also use a putty knife to break loose the old faucet. Be sure to carefully wipe down the sink before you remove it. Once the old faucet is removed, install the new one.
Once you have taken out the old faucet, you need to replace it. This project can be simple enough, but you can complicate it by removing additional plumbing in the sink, such as the garbage disposal, drain trap and a few other parts. You should be aware of any potential problems that may arise as you work, especially if you are a novice. Before you begin, take photos of the old faucet so you can remember the configuration. If necessary, use caulk and Teflon tape around the supply-line connectors.
Remove the old faucet
To install a new faucet, first remove the old faucet. If it comes with pre-attached tubing, you can skip this step. However, if the supply lines are manually attached, you will need to disconnect them. To do this, simply twist the mounting nut counterclockwise until it pops off. The mounting nut is usually located in a tight space behind the sink. If you need a firmer grip, use a basin wrench.
Watch online videos
While you can replace a faucet yourself, it is important to pay attention to the details and be patient. There are many small parts that need to be assembled correctly. If you make a mistake, you could end up with a leak. Therefore, if you don't have any experience with this, watch online videos to learn how to replace a nivito. To prevent injury, you should have good physical strength and be able to reach the tight areas and turn various nuts and bolts. A basin wrench will come in handy to gain a firm grip.
To install the new faucet, make sure to keep the existing one intact. You should have the required space and enough time to complete the task. It is vital to have a clear space to work with. During this process, you should have enough room to move and do other tasks. Taking a little extra care of the cabinets will save you the hassle of replacing the faucet. Then, you should connect the supply lines to the new faucet.
Flush the water lines
The next step is to flush the water lines. You should do this by removing the aerator and then removing the nozzle head. You should do this process once or twice to ensure that the new faucet is working properly and that it does not leak. In addition, you should take precautions to protect yourself from accidents while replacing your kitchen faucet. Once you are sure that you are following the directions correctly, you can proceed to the next step.